Fortinet NSE6_FWF-6.4 Dumps

This frequencies are also used by other licensed applications, wireless LANs have to use a specific method to gain access to certain higher frequencies and this method is known as DFS.

According to the web search results, the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration is static. This means that the FortiAP sends discovery requests to a preconfigured IP address that the controller owns. This is useful if the FortiAP and the controller are not in the same subnet and other discovery methods will not work. The other discovery methods are used in sequence if the static method fails or is not configured. References: Advanced WiFi controller discovery | FortiAP / FortiWiFi 7.4.0

According to the web search results, the project information phase and the site survey phase are part of the process to plan a wireless design project. The project information phase involves defining the project scope, objectives, requirements, deliverables, and stakeholders. It also includes creating a project plan, a risk management plan, a communication plan, and a budget.1 The site survey phase involves conducting a physical inspection of the site where the wireless network will be deployed, measuring the signal strength and interference levels, identifying the optimal locations for the access points and antennas, and validating the network performance and coverage.2 The hardware selection phase and the installation phase are not part of the planning process, but rather part of the implementation process. The hardware selection phase involves choosing the appropriate wireless devices, such as access points, routers, switches, controllers, and cables, based on the network design and specifications.3 The installation phase involves installing, configuring, testing, and documenting the wireless network components according to the project plan and best practices.3 References: Wireless Device Network Planning and Design - Emerson, Telecommunications and Implementation Project Management - BICSI, Project Planning | Wireless Design Services | Digi International

The wireless network interface must be assigned a Layer 3 address because it acts as the gateway for the tunnel mode SSID traffic. The FortiGate wireless controller uses this interface to communicate with the FortiAPs and the wireless clients. Without a valid IP address, the tunnel mode SSID cannot function properly. References: Secure Wireless LAN Course Description, page 5; [FortiOS 6.4.0 Handbook - Wireless Controller], page 24.