Winter Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: dumps65

Huawei H12-425_V2.0 Dumps

HCIP-Data Center Facility Deployment V2.0 Questions and Answers

Question 1

Which of the following is a standard component in the FusionModule800 typical configuration?

Options:

A.

PAD

B.

Video surveillance system

C.

Intelligent lock

D.

iBattery

Question 2

What are the application scenarios of lead-acid batteries in Huawei FusionModule2000 standard configuration?

Options:

A.

Battery pack

B.

Built-in battery cabinet

C.

External battery rack

D.

Battery box

Question 3

Which of the following position is recommended for installing the smart ETH gateway?

Options:

A.

Control skylight

B.

Inside a network cabinet

C.

At the inner side of a door header

D.

At the side of a cable trough

Question 4

What are the benefits of PowerEcho for the NetEco?

Options:

A.

Web-based unified maintenance interface

B.

Operation wizard

C.

Quick fault locating

D.

One-click health check

Question 5

In the water-side free cooling solution, cold water cannot be transported directly from the cooling tower to chilled conditioner?

Options:

A.

True

B.

False

Question 6

In operant conditioning, the subject is free to make responses at any time, So conditioning is measured by the rate of responding. In most other Ways, however, their forms of learning are essentially the same.

Options:

A.

When UPSs are connected in parallel, connect loads to the pL terminal.

B.

When a single UPS works and loads are of the same importance, connect all loads to the sL terminal.

C.

When a single UPS works and loads are divided into two levels, connect the primary load to the sL terminal and thesecondary load to the pl_ terminal.

D.

When the UPS is overloaded, the loads connected to the sL terminal will be powered off first to ensure continuous power supply to the loads connected to the pj_ terminal.

Question 7

If multiple SmartLi battery cabinets are combined, press and hold the POWER ON/OFF button on each battery management module for more than 2s, and then switch on the battery circuit breaker in any cabinet to start all battery cabinets.

Options:

A.

True

B.

False

Question 8

During filling refrigerant for NetCol5000-A, there is no need to put the refrigerant steel cylinder upside down on balance.

Options:

A.

True

B.

False

Question 9

Which of the following statements are true about the dry contact card of the integrated UPS?

Options:

A.

After the BCB port of dry contact card is connected, the BCB port can be used only ifit is enabled on the monitoringsoftware.

B.

The EPO port can be normally open or normally closed.

C.

The UPS dry contact card can be used to detect the switch status of the battery system.

D.

The dry contact card cannot detect the status of an external battery switch.

Question 10

If the battery charge current limit coefficient of the UPS5000-E is set to 0.1C10, which of the following statements about this parameter is true?

Options:

A.

The maximum batten/ charge current is 0.1C10.

B.

The batten/ charge current is always 0.1C10.

C.

The battery float charge current is 0.1C10.

D.

The maximum battery charge current is 0.1C10.

Question 11

To modify the FusionModule2000 plan view of the ECC800-Pro, users need to log in to the WebUI as admin account.

Options:

A.

True

B.

False

Question 12

Which of the following are components of NetCol8000-E220? (Choose three.)

Options:

A.

Indirect heat exchange system

B.

Mechanical auxiliary cooling system

C.

Spray system

D.

Electric control system

Question 13

Which of the following menus can be used by engineers to manually add devices on the NetEco?

Options:

A.

Data center planning

B.

Report management

C.

Alarm management

D.

System management

Question 14

A data center is at the Tier IV level and uses Huawei FusionModule2000 smart module. In this smart module, the PDU8000 integrated PDF cannot be used to supply power to IT loads and precision air conditioners at the same time because isolation requirements are not met.

Options:

A.

True

B.

False

Question 15

Which of the following PH values meets the water quality requirements of NetCol8000-E220?

Options:

A.

3

B.

5

C.

7

D.

9

Question 16

as

Options:

A.

2N deployment crossing rows

B.

2N deployment without crossing rows

C.

N+1 deployment crossing rows

D.

N+1 deployment without crossing rows

Page: 1 / 6
Total 55 questions